MIX UP - Universal Router for Arduino

Arduino™ is the most popular prototyping and development platform but present very common problems with conflicts on the channels assigned by the creators to different shields.

MIX UP is dedicated to the solution of this problem.

This is a very simple shield for Arduino™ or any other compatible board that allows, using switches, to route each single channel, analog or digital, to any other. With MIX UP you will be able to solve the conflicts in seconds, and to combine shields that used not to be compatible before. All this without the need of wiring and soldering, under the form of a neat board that can be reused an unlimited amount of times.

WHAT KIND OF PROBLEMS DOES MIX UP SOLVE?

Two shields designed from different companies often use the same channels on the Arduino™. This makes it impossible to use both the shields at the same time, unless you modify at least one the shields or stuck with messy wiring to change the channels in one of them. With MIX UP in a few seconds you can route the signals to different channels and solve the problem!

Many shields don't offer headers and some others cannot be stacked. This is a limit to the expandability of the system you are designing. MIX UP allows to add more shields to the system, without requiring any soldering or wiring.

Finally, MIX UP helps you also when you need to use shields that don't offer headers but you still need to use wires, for examples to connect components located on a breadboard. With MIX UP you will have an additional full set of headers available. And not just that! You will be able to reroute the signals without messing up with wires, just using the switches on the MIX UP board. 

All the technical details are available from the Wiki page